Edge tank on Talon/SS/Condore
I would very much like to make as close to 12ftlb rifle using the Edge tank. So i was just wondering if any one had tried a Edge tank on there none edge rifle and wondered what you ended up with?
I am guessing that bigger caliber, longer barrel, heaver hammer, stronger spring will all help the tank get closer to the 12ftlb mark over the stock 6ftlb of the Edge.
Also has any one had a Edge tank apart? Is it possible to increase its regulators operating pressure or perhaps port the valve to increase flow?
Any thoughts or advice on achieving my goal would be most appreciated.
Thanks
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
Well it isn’t finished yet but its almost all there, here is the tube with the end plug.
Hay Dave I’m in Yorkshire England. Do you have any photos of what you have there? Cheers
Where are you located? I have an Air arms S410 tube that has an end cap and an adapter to thread in a standard Condor/Talon valve that I wouldnt mind selling
Dave
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Got the other adapter finished today, filled the tube with water and then pumped it up to 250BAR, going to leave it overnight and then I would say that it is safe for the maimum fill pressure of 190 bar that is stamped on the cylinder.
Dave