Edgun R3m .25 stainless HST adjuster 450fps to 885fps
tested the new long stainless HST adjuster at 115B regulator pressure:
shooting kings 25.4g
450fps and have 4 threads still threaded in the action——> still vary tight shot string
735fps HST adjuster setting in the photo—> my back yard setting, its so quiet and accurate at this speed.
885fps is the max speed at 115b reg pressure and have 4 -5 threads till it bottom out on the action.—–>880fps is my preferred high setting—>that’s all the power I need, 5fps below max speed at 115b, this way I get the tightest string with the most shot count. I also tested at 130b it max out at 945fps with kings and have more threads if needed, and can lower below 500fps.
The finial adjuster will have holes on the flats of the square so you have two ways to adjust and come with 1/4″ wide jam nut so you don’t have to use the set screw that will damage your threads then damage your action threads when you back out the adjuster.
Have listed all the members that wanted the adjusters when I have them made about 2 weeks.
the stainless HST adjuster is included with my tunes if you don’t have one. will work on all matador.
Attachments:
All Replies
Viewing 10 replies - 1 through 10 (of 10 total)
Excellent, I do believe that would be the solution in case we had loosening. Was simple too, DUH….
I can’t remember. I thought it was Lyndon2472 from the UK maybe?
I have one question, i have been using an aluminum version of this for 1 week and i’m a bit concerned that i cannot get sufficient torque on the jam nut with finger tips to feel confident it wont vibrate loose, do you have any thoughts about this ??? It has not happened in the one shooting session i had, so maybe unfounded but i can still envision it.
Was this the one that we bought from eBay???…. Cause I bought one off eBay from a user on here. And it works great.
What’s the damages$ I some how missed this.
Looks great.
I PM’d you earlier in the week when you made the initial post saying I was in for one but didn’t receive a reply. Just confirming I still want one. 
Haven’t loosen yet, If it did I would lightly double jam it with the square end turning CW! 😯
That looks sooooo good, I CAN’T WAIT.
Yes I have a black anodized one with the jam nut and ended up reusing the set screw when it loosened on mine.
I have one question, i have been using an aluminum version of this for 1 week and i’m a bit concerned that i cannot get sufficient torque on the jam nut with finger tips to feel confident it wont vibrate loose, do you have any thoughts about this ??? It has not happened in the one shooting session i had, so maybe unfounded but i can still envision it.
Bravo !!
I have one question, i have been using an aluminum version of this for 1 week and i’m a bit concerned that i cannot get sufficient torque on the jam nut with finger tips to feel confident it wont vibrate loose, do you have any thoughts about this ??? It has not happened in the one shooting session i had, so maybe unfounded but i can still envision it.
Viewing 10 replies - 1 through 10 (of 10 total)
- You must be logged in to reply to this topic.
looks good. so how do we get on the list? PM?