Ffs
Ok not having the best of days…. The o ring that’s at the back of the barrel where probe goes it I’ve got blow back so I assume it needs replacing, so the brass bit does that come totally out and I have all o rings which is it…. I’m hoping the brass bit does come out as I don’t have magic finger just fat sausages
All Replies
Viewing 9 replies - 1 through 9 (of 9 total)
I will lol
Great, next time you degas the air tube use the method above, so easy and no scary pop and you won’t loose the oring just make sure the pressure is at around 100bar
Ok o ring sorted and I pushed it in lol
You don’t wana scratch it, the pellets pass by there just try to lube the oring and push it inside
I’ve moved it few mm but won’t come out
It’s a bit hard to get it out just push the oring inside the cavity without removing the brass
I’ve taken it apart I’ve removed grub screw but does brass bit come out?
Next time try to degas your gun following this method http://www.talonairgun.com/forum/viewtopic.php?t=32072
As for the brass it’ pain in the ass to remove, you have to remove the barrel block from the reservoir to get access to the holding 1.5mm hex screw, i usually just put some silicone grease on the new oring and push it in place using a toothpick
Viewing 9 replies - 1 through 9 (of 9 total)
- You must be logged in to reply to this topic.
Ditto!! Thanks Gerard.