For Sale: Kalibrgun Cricket – Swing Out Single Shot Tray
I have two of these bad boys in 22 and in 25 cal. 3-D printed In black PLA plastic (not white as pictured). PM me if interested.
Pellet/bullet chamber has a grove for a rubber o-ring (NOT included) to hold the projectile securely. It’s same size as the barrel o-ring.
You can take the two pieces apart, or you can secure it with a small pin for a more permanent configuration. The pin hole is premade. Some VERY minor sanding might be needed to adjust the tightness of the fit for your individual preference.
Here is a video of this design: https://youtu.be/JbG_0kkqE3Q
$30 shipped, PayPal gift or + 3.5% fee
I am on BOI
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
It did not fit in the slot to load the pellets ,
Mike
Was probably from me – what was wrong with it? I’ve had no issues with it all… PM me
I bought one like the white one from some one on here for my 22 cricket,
It never worked , But I do not remember who I bought it from, it was not black , It was white.
Mike
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
OK , before I retest it what was the size of the oring ?
I will check back because I am sure I screwed up some where.
Mike