Q:

FX Bobcat Regulator adjustment Video

OK the Bobcat use the same block and regulator, this video show you its vary easy to remove and adjust or just to reseal the regulator. on the BC the gauge and foster fill is in the different location,

Ernest


Attachments:

FX Air Rifles

All Replies

Viewing 14 replies - 1 through 14 (of 14 total)

Thanks!

quote wvbowhunter:

What do you do to the regulater to increase velocity?

tighten the washers / springs, by doing so it will take more regulated pressure to cutout the supply end, higher reg pressure = higher speed/FPE

What do you do to the regulater to increase velocity?

Did you drill the breathe hole? Have read this somewhere, seemed not that simple. Kept me from getting a reg for my cat.

Thank you very much. I hope Ernest may have some ideas about this issue.
Thanks again.
Alfredo

It sounds like the airs going around the regulator or the regulator needs adjusted. PM Ernest, he’ll have the answer. And welcome to TAG.

Hello everyone. I am new in this forum. I just bought an FX Bobcat cal 22 (5.5mm). I bought it without a regulator. I bought a few days ago the regulator from AoA. I install the regulator. There is no leaks. There seems to be no problem al all. When I make the first shootings, the pressure goes down very fast and from 200 bar I go to 150 bar in five shoots. I install the regulator watching the video mentioned. Do you know wich should be the problem ??
Thanks
Alfredo

Thanks for another Great video.

Kevin

yes, but your shot count will be less then 2 mags.

Ernest

Thanks for another great video Earnest!
Is the .25 Bobcat capable of 950+ fps. speeds?
Frank

Brother Ernest; you are an air rifle specialist.

we appreciate your efforts always.

yes sir thank you ernest… been search hi and lo and waiting a while for a post like this :7:

Just one ? how do u know what u have it adjusted to?

Hi ernest
Another very useful video
Rgds steve

Another great video from the MAster. Thumbs up Ernest!!

John

Viewing 14 replies - 1 through 14 (of 14 total)

  • You must be logged in to reply to this topic.