Gunpower Storm silencer.
Does anyone know how this thing is put together? At the rear end of it, about an inch in, there is a join line, but I cannot get it un-screwed. Is it glued on, screwed on or both?
TIA
All Replies
Viewing 1 replies (of 1 total)
Viewing 1 replies (of 1 total)
- You must be logged in to reply to this topic.
Never mind, it was a push-fit. Managed to screw-driver it off, disassemble the internals, a good couple of hours reaming it out so it would fit right down over the barrel, sorted. Eee, it look reet GRAND! And completely eliminates the noise of firing too, which is why I made the effort after already having adapted the smaller one.
I used the knurled handle of a socket-wrench to ream it out, rolling the silencer on the floor like a wheel with the wrench handle as an axle. That’s one cheap-ass lathe substitute. 😆