HELP! (agian)
I do not know what i did this time, but after i took my air tank off the AF pump and screwed it into my gun, i went to take it out for some shooting. the first thing i relized was the breech would not close properly like it normaly would. it required a little more force. then after that i shot the gun and the pellet did not even reach the target( 44m away) , it hit the ground in front of it. is it possible that i “bent” the end of the air tank? what i did notice when i was pumping the tank up is that if i left it stationary, the PSI in the valve between ther air tank and the pump droped slowley, but steadely. is that supposed to happen?
All Replies
no i dont think it is that, the breech slides in and out smoothly with out the tank
sounds like you need to get a new tank -you may have tweaked the stem–dangerous maybe- you really should not be wrenching on the bottle at all-put a dime (coin) or two in the fill adaptor slowly screw the bottle on until you hear a faint hiss and very slowly empty the tank- with the tank empty actuate the valve – you should be able to tell if you bent the stem…..
Check the breech seals. Being worn can cause the breech not to seat on the top hat properly.
- You must be logged in to reply to this topic.
no i dont think it is that, the breech slides in and out smoothly with out the tank
empty the tank.