Hey WOK you crusty asshole, what do you think about this?
You did state folks sometimes were nasty when requesting favors… 😆
need a custom WOKguard, be overlength.
reason being I need it for my “Osprey” 9mm
be a bit different than you guys are used to
looking at a remote line for bench, a stainless in stock pressure tube for a max of two or three shots in field at 150 FPE
will be using the full length Troy free float hand guard on the build, {even you wont be able to bitch that this isn’t a free float when done}
pic gives you a rough idea of layout with the short guard
what say you? This brings AF custom builds to a bit different level don’t you think?
All Replies
WOK:
will run up some measurements…
idea is to free up the grip lug hole so I can use it in conjection with a single lever safety most likely with a highly moddified inch pattern FAL selector with the detent socketed in the original tank insert. The new inset retainer will also retain the rear end of the 1913 rail.
Measured up my 1913 rail stock, should be able to cut a concave to match the contour of the AF frame with a socketed dovetail @12:00 to match the Troy free float guard…lots O’ meat there.
Be a screw & glue affair like the original AR A3 rails once were
Voltar:
You old stick in da’ mud 😆
I did state that it was to provide an idea of the general layout 😉
I don’t see anything Airforce there at all.
No problem lets do it. I just need a drawing and some specs. 😀
BTW good call on my asshole being crusty 😛
- You must be logged in to reply to this topic.
Do I spy an E-TaC??
Jim