How do I remove the hand grip ?
What else do I need to do to remove the pistol grip from my Condor ?
I removed the three visible screws from the girp. But it seems there is more to holding it on. ? Up inside the handle I see a screw of some sort. It doesnt look like an allen or standard type screw ?
Thanks
Bill fm WA.
All Replies
Viewing 9 replies - 1 through 9 (of 9 total)
To rmove the grip you need a 5/32 hex wrench at least 4″ long….
Spend the money and get a good set and dont look back.
shine a flash light up there and figure out what it is, who did you buy the gun from? if you can’t figure out what it is then send them an email or whatever and ask what they changed it to and why.
Just beat it with a big hammer. It will come off. 😆
Its not an allen screw. I used the 3/16 allen wrench and there is no allen hex to fit the wrech into. It is almost the same size as the 3/16 wrench.
It almost looks like a nut . Cant’t see any difined out side hex shape like a nut would have.
If 1 half of the grip has 100% of the bolt hole and washer that will work, if the grip comes together so that each half forms the full circle then he’ll likely end up breaking something for the sake of a $1 allen wrench. If it doesnt break, it wont be as tight when it comes to putting it back on.
If you take those three screws out and manage to get a grip half off, there is no need to dig for a super long hex wrench.
It needs a relatively long Allen wrench.
You may as well put those 3 little screws back in while your at it so they don’t get lost – They just hold together the two halves of the grip and don’t need to be removed to remove the grip.
all you need to do is remove the allen screw from inside the grip, the size allen is 3/16
Viewing 9 replies - 1 through 9 (of 9 total)
- You must be logged in to reply to this topic.
I got it,, It didnt look like an allen. But it is.. just like you all said.