How to degas veteran?
Is there any way to do this?
I’ve seen a video which shows a pin being inserted into the adjuster cap instead of putting the hammer spring in, but I don’t have that
All Replies
Viewing 6 replies - 1 through 6 (of 6 total)
.
To remove the valve end cap off of the receiver.
From what I’ve seen but haven’t done it myself yet ……….
Place a rod (or metric drill bits shank end) into the 4mm hole on the side of the end cap and turn it to loosen.
I don’t think there’s anything else that is holding it, IDK.
~ Greg
Thanks a lot for all your help Greg, much appreciated
I have it all apart now, but I can’t figure out how to remove he valve body itself … any help pls anyone?
Thank you
Now I can’t seem to pull away the rail section from the main block .. I mean, the trigger wire won’t pull away from the trigger mechanism … pls help lol
PM sent ……
~ Greg
Done it!
Thank you
Now I can’t seem to pull away the rail section from the main block .. I mean, the trigger wire won’t pull away from the trigger mechanism … pls help lol
.
Make sure the gun is decock and fined something similar to place into the HST.
– Greg
Viewing 6 replies - 1 through 6 (of 6 total)
- You must be logged in to reply to this topic.
All disassembled, now to polish this transfer port