How to do a tune on talon ss valve
I just got my Talon and keep reading about a valve tune, anyone know how to do it or have a tutorial.
thnaks
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
Kejano25
Dont use a dremmel to drill with, it turns way too fast for all but the smallest drills. Thats what burned out your drills — turning them too fast.
Mark
Actually just did that last week wasnt to bad xcept whatch how you drill the valve stem!!! I bought 5/ 2.8 , 5/ 3.0. And 5/ 3.2. Mm drill bits and got half way thru with each bit but then only the first two would go thru? The 3.2 wouldn’t go ? I used all five and it rounded after just a few seconds, so I went out and got more , first batch were blu- mole second were from ace as singles. I bought six, tried It again and rounded those even faster, so I left it at 3 cause my dremel was starting to smoke and the valve stem started turning orange. Polish polish polish but not too much use 1200 grit, and read that article triggerman mentioned and u should be fine. Good luck
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
thanks for sending me in the right direction.