How to take off the pistol grip?
Sound prbably pretty dumb to ask this cuz it is probably very easy to do but I never went inside of my Tony tuned Condor and I wanted to fabricate my own pistol grip- just worry if I unscrew the bolt inside will trigger assembly fall out or is it totally independant part?
By the way, guy, when you make your own grip do you drill vertical hole through it to screw it to the gun? Any advise will be appriciated.
Thank you
All Replies
Viewing 8 replies - 1 through 8 (of 8 total)
thank you guys! Is the screw that holds the grip is the same that holds cylidrical collor for the tank?
Be careful when putting the new grip on the rifle. If the bolt is too long (or the hole too deep in the grip) it will thread through the cylindrical nut thing to contact and deform the bottle collar that is attached to the frame.
If you have the tank off you can just see the screw pass through the cylinder nut…
Drill a hole all the way through for the bolt.
Thank you Adam! When I make new one do I have to make it hollow inside for that screw to come in? I think that is the only way, am I right?
Turn your gun upside down. Look inside the grip. You see that bolt. Unscrew it.
Thank you, but how the hell do you search for it in there. I tried and didn’t get what I was looking for. Do you have link to the post that talks about it?
check quick reference section
Viewing 8 replies - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.
no the collar is held in with grubs.
drill your bolt hole square in your blank first before cutting your dado and shaping, run all of your cuts off the center of the bolt hole also use an angle finder for the grip angle then cut your blank to that and start shaping.