HST driving OAKS NUTS
Love the Matty .25 but the HST lock nut keeps loosening up today it was shooting at 777 from 910 to 915. Ernie says loctite blue. I just want to drill a set screw in it and say enough’s enough.
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
~ GReg
Yeah missed shooting more then I thought. Good too see you Greg.
Sure no problem, I’m glad to see you’re back and shooting again Oaks !
~ GReg
Thanks Greg. Think somewhere along the line I once did that just have not been shooting or on my guns in about a year..
Bignuts, Bluenut, Peanuts and them Numbnuts seem to be all the same, they need degreasing.
Not sure which HST u got Oakey OEM or the one from Ernest/John ?
If you got Ernest HSTA I’d take his advice and blue lock it after giving the treads a bit of degreasing/cleaning out with denatured alcohol.
If u still got the OEM u’d might try adding a O-ring between the lock nut, a Buna-N 90 (don’t lube) with a smaller ID size then the shaft.
Also in conjunction with a 3mm hex u can add a piece of weed whacker cord cut at an angle or a cut off a O-ring (don’t lube) and placed into the small lock down for the HST, seen here ….
http://www.talonairgun.com/forum/viewtopic.php?f=34&t=33456&start=20#p343253
…… … so Houdini where have u been and what else beside an Edgun do u shooting ?
~ GReg, p.s. the trick is not to use any grease/lube anywhere throughout in the affixing only on the HS.
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
~ GReg
Yeah missed shooting more then I thought. Good too see you Greg.