Is there a lead slug casting setup for .25 caliber?

I don’t understand the .257 caliber. Why not have made it a flat .25 caliber?

Then us lowly .25 caliber owners could concentrate on powering up our valves, and increasing the length of our barrels to get the long range assets offered by the .257…

Anyway, if I wanted to cast some .251 or .252 diameter slugs, especially hollowpoints, where would I begin the search for the molds and furnace? I’d be fine with 35gr to 50gr slugs for the critters I try to drop with .31gr Barracudas? I wouldn’t put an Ein Jin 43gr slug in my Edgun Long.

I believe there is a lot of FPE I could benefit from with cast slugs, and no one to my knowledge has tried to max out the Edgun valve/reg setup. Might be fun to try a few things.

By the way, any suggestions where i can recycle lead from local sources?

Thank you muchly…and Merry Xmas!

H 😯 😯 t

“Kill it till it’s dead!” anon.