Looking for some tank valve advice.
I have a 90 cui carbon tank by venturi, that is regulated output 2900psi which was fine for the Mrod but my new gun charges to 250 bar or closer to 3500psi. My question is there a replacement valve which will allow me unregulated flow to replace my 2900psi setup.? And were can i find one?
Thanks
Sent from my P022 using Tapatalk
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
Knife
Thread is different. I have seen some instances where someone has re-threaded a paintball tank to accept a standard SCBA valve, but not sure what that would cost if you couldn’t do it yourself.
If the threading from a standard SCBA tank valve will fit, they are available on the Bay most days. I think I paid 49.)) for the last one I bought to replace a worn out one on my 88cf Scott.
Knife
Yikes ,thats steep for a valve , 120$. Is that only option? Dont really need a gauge… wish they had picks
Sent from my P022 using Tapatalk
Thanks
Sent from my P022 using Tapatalk
http://www.airhog.com/index.php?id_product=81&controller=product
they have one with gauge for an additional $15 too.
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
Went and bought a used Scba 44cu ft. Instead of dropping money on a valve. So if your in the market for a 90cu in carbon tank u know where to go..
Sent from my P022 using Tapatalk