Lothar Walther barrel blank straight from the manufacturer
Hello guys, I just bought a Lothar Walther barrel blank straight from the manufacturer. Now my problem is what do I need to machine to make it drop-in ready for my Condor.
Now its looking like this
http://www.google.com/imgres?hl=en&safe=off&sa=X&tbm=isch&prmd=imvnso&tbnid=NyQ5XW5p2B65DM:&imgrefurl=http://itrademarket.com/milzone/2493325/lothar-walther-air-rifle-standard-barrel-4-5mm.htm&docid=mUvqbADYTUE_vM&imgurl=http://wb6.itrademarket.com/pdimage/25/2493325_mz.walther.barrel.jpg&w=800&h=600&ei=9czcTuXvOMTsOfrczeQM&zoom=1&biw=1024&bih=581.
Any input is welcome.
All Replies
Viewing 7 replies - 1 through 7 (of 7 total)
Why not just send him your stock Condor barrel so he can get the fit just right?
I’d care more about getting that new barrel just right then i would about having a gun outta commission for a week or 2
airforce shotgun… 😆
if nobody chimes in, check quick reference or post this over in mods/machinists, somebody knows… 😉
Money LOL,
That a good one man LOL… As I was laughing at you, I was thinking about how big the tophat was going to be LOL…
The profile of the Condor barrel will need to be for what size of bushings you have or have made for it, to start with… Then make sure to neck down the unchoked end of the barrel for the breech end…
My bad it OD 16mm not ID 16mm facepalm.
16mm ID???
airforce shotgun… 😆
if nobody chimes in, check quick reference or post this over in mods/machinists, somebody knows… 😉
I already have a guy, just need the measurements to get the barrel machined to drop in the Condor frame. The ID of the barrel is 16mm. How long and to what ID does the barrel needed to be machined on the other end to fit into the frame?
@moneyshot thx for your offer.
depending on where you live, i could suggest quite a few guys here that could fix ya up.
Viewing 7 replies - 1 through 7 (of 7 total)
- You must be logged in to reply to this topic.
airforce shotgun… 😆
if nobody chimes in, check quick reference or post this over in mods/machinists, somebody knows… 😉
Money LOL,
That a good one man LOL… As I was laughing at you, I was thinking about how big the tophat was going to be LOL…
The profile of the Condor barrel will need to be for what size of bushings you have or have made for it, to start with… Then make sure to neck down the unchoked end of the barrel for the breech end…
The busings stadard, ordert them from Jim. The unchoked end of the barrel is the one with the caliber markings or the other one? How long has the neck down part has to be and what OD does it have? I don’t have any other barrel to take the measurements (sold it before I got the blank :banghead: :banghead: