My Condor has a problem
The slide breach doesn’t remain in the fully open position. It moves closed about a 1/2 inch. Any ideas?
All Replies
Viewing 6 replies - 1 through 6 (of 6 total)
Did you remove the Safety auto reset device ?
If so, move the safety in the off, forward position then cock.
~GKU
It moves far enough back that I can’t see tue end of the barrel to load a pellet.
do you mean when you push it all the way forward to cock it,that when you let go it moves back slightly?
if so that sounds normal to me,
the backwards motion from when its full forward is just the hammer coming to rest on the trigger group.
:2cents:
unless thats not what you mean ?
Might be time for some new oring in the bolt.
Can you post a pic
Viewing 6 replies - 1 through 6 (of 6 total)
- You must be logged in to reply to this topic.
The safety is long gone. Once in a while it stops where it should. 99% it doesn’t it moves toward the valve 3/8in or so and covers the end of the barrel.