my recipe for 177 fun.
Take one standard mutant, one standard s200 .177 barrel, one s200 silencer adaptor and assemble together by removing rear cap from ldc onto breach end of barrel to the silencor adaptor and screw ldc onto adaptor and endcap at same time. Tighten up, clamp barrel tight into breach without use of grub screw. Use single shot adaptor, load pellet with gun pointing down or feed pellet in and blow pellet into breach to help it locate.
CHECK THAT COCKING LEVER RETURNS TO CLOSED POSITION GENTLY SO THAT 5.5MM DIA SECTION OF PROBE DOES NOT IMPACT ONTO THE BARREL. On mine there was clearance.
Note barrel will sit out by a couple of mm as the mutant barrels have some material faced off.
The standard transfer port will be smaller than mutant transfer port and will notline up correctly but seems to be ok.
Not found perfect pellet yet.
Woukd consider buying a standard probe to modify to .177, and make a brass bush to suit pellet and suitabke oring and sleeving magazine too.
Hope pictures come out.
Attachments:
- You must be logged in to reply to this topic.