need help, mag is stuck…..
ok i had my nephew try shooting vulcan today after Christmas lunch.
he had trouble working the bolt, his young & it was his first time with the gun.
well he tryed working the bolt, and it only went half way.
it will not go forward past half way.
i can’t get the mag out of the gun, i think a pellet is stuck, and that may be why.
i took the ldc off the barrel ran a cleaning rod down the barrel, nothing gives way.
what should i do. 🙁
thx.
All Replies
ok i got the set screw off back on the top, by the mag well.
i can’t pull off the barrel. must be jammed up maybe a pellet in the barrel, with the mag stuck in the mag well. and i can’t move the cocking bolt passed half way.
whats next any ideas any body.????
thx
ok i can’t tell how too get the last single screw off end back on the top, by the mag well.
i used a small allen, a small screw driver, but nothing works.
can some one plz give me some tips, how get that off.
thx
good morning all….
ok guykuo….. i did try all the easy stuff & obvious first.
ernest….. i’ll go & get a wooden rod.
question, will i be able too get the barrel off,
with the mag stuck, in the mag well??? 🙄
then i’ll give it a try.
and let u guys know how it went. glad u made your videos on the vulcan ernest.
and kris…… i’ll look into the spring as well.
i’ll post soon how things go.
thx for all your help!
the problem is again that fat wired spring on the barrel.replaced mine a while ago. much better
Remove barrel and shroud—->use a wooden Dow rod that has a 3/4 the size of the barrel ID, make sure the pellet end of the rod is flat–shove w-rod till it touch the pellet then cut the rod 1″ -1 1/2″ from the muzzle, use a wooden paddle about 1″ thick about 5″ 2′ wide 2′ long—–> lay the breech end of barrel on wood then smack the rod almost hard as you can till the rod move down word—->works every time.
Putting all your weight on the rod doesn’t work—-the above procedure will chill shock the lead loose.
Just to take care of the obvious first…. the No-Rotate slider is forward, right?
That will also lock the magazine into place.
I think you need to remove the barrel to get a jammed pellet free.
I bet there is more than one pellet in the barrel and the last one has its
skirt deformed laterally by the attempts to remove the magazine.
Decock the trigger first.
Remove the barrel. You can follow the directions in Ernest’s video.
That should pull the deformed pellet forward with the barrel.
If not, it will at least give you access to push the pellet back into the magazine
eelect….
yes i did try that did not work. 😐
Try to work the mag spokes and see if you can free mag if it’s stuck. You can get at the spokes from the side of mag
Sent from my Z30 using Tapatalk
- You must be logged in to reply to this topic.
I would suggest posting a few pictures so others can clearly see what you see. It may trigger different ideas.