Need help to assemble Condor frame internals….
I took apart my condor internals . Any one has a diagram or video on how to assemble the internals.
Appreciate help here . Thanks.
All Replies
I did remove the power indicator screw . Will try doing this while pulling the trigger . I didnt do it this way before . Hope this helps solve the issue .
Thanks guys for your help .
loosen the barrel again.
take the pressure off the hammer spring.
push the trigger.
and push the barrel back in while pushing the trigger
fix barrel again
and :4:
and don’t ever forget to remove the power indicater screw before dismanteling the gun!!!!!!
Just checked they are as you suggested . What next !
Next time, Drop the breach in from the muzzle end, along with the hammer. Keep the trigger pulled while doing this. This will allow everything to drop into place. 😉
Mike
ok thanks alot I will try it and see . Need some time to do this .Really appreciate your help.
http://talonairgun.com/forum/viewtopic.php?t=13063
lift nr 15
put nr 16 under
you don’t have to remove the pins
Along with the trigger the part where the trigger screws on to was also removed ( which is fixed by one pin ). This has been put back now.
remove the plate that covers the trigger group you got to to lift one part up a little and put an other one underneath it and it wil work fine again i guess
Only the trigger was removed rest of the stuff like sear ,safety etc were not . If I try to put the breech from gthe barrel end it gets stuck in between and does not go in till the valve end .
was the trigger group also removed?
by the way much easier to put and remove all from the barrel end
I did put it in – the long spring .
I am sort of confused this is my first time doing this. All the links show the order in which things are to be put . What am I missing here . I put the breech in from the valve end and then the rest of the stuff like hammer,spring,powerwheel from the barrel end and screw in the power wheel screw . After this the gun wont cock .As mentioned earlier the breech is loose and moving freely .
forgot the hammer spring? 😕
I tried putting the breech from the valve end it went in and then I put in the hammer and other parts from the barrel end . But I am unable to cock the gun. The breech is kind of moving about loosely.
- You must be logged in to reply to this topic.
Its done finally . Thanks to all for their help .