Need instructions to de-pressurize a gen 3 vulcan
Pretty much the title says it all. Gen 3 apparently doesn’t have the bleed screw any more. How do you depressurize the cylinder? I am going to try adjusting the regulator and will need to fill and empty at least once if not several times to get it right.
Thanks!
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
Just don’t have the hammer spring in or you’ll be sorry :rofl:
quote Voldemort:
screwed it in until the hammer had enough force to open the regulator and bleed off the cylinder
I’ll be following you Chiro. Keep us posted on how your regulator adjustment goes.
I saw a post where a guy took a longer screw with the same threads as the hammer spring adjustment screw and just screwed it in until the hammer had enough force to open the regulator and bleed off the cylinder. Worked great.
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
Just replace the hammer spring with small plastic tube. I used part cut off ballpen
Then screw powe adjuster Very Gently in.