New Idea for Cheap Ass butt plate ( on tank ) No Pics.
What if you were to take a 2-5/16″ hole saw ground down the teeth (drilled and taped for WOK Butt) that fit the end of the bottle (of course without drill bit in it) And epoxy that to the tank. The cup should give you a much more stable fit and alot more surface for the epoxy to bond to. It would be Similar to http://talonairgun.com/forum/viewtopic.php?t=4445&highlight=butt+plate
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
quote WalkonKing:
It would work for sure. But once a metal disc is JB welded on it is not going anywhere.
Ohhhhhhhhh!
It would work for sure. But once a metal disc is JB welded on it is not going anywhere.
quote WalkonKing:
Or use one of these
So you don’t think a cup design would be more stable?
Or use one of these
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
or use that same cup drill to cut a nice circle plate to epoxy to the tank.
A little of both ideas.