New member safety problem
Hi all
My first post.
I have a new to me Condor. I was target practicing.
Something in the safety went south. When you cock the bolt it doesn’t catch. I noticed if I pulled the safety back manually it would catch.
So Its a spring – safety problem.
I don’t know How it goes together.
Any of you have a diagram of this mechanism? instructions on how to fix?
thanks
ziton
All Replies
Viewing 7 replies - 1 through 7 (of 7 total)
Took a while.
Something I needed to know.
Thanks
So what fixed it?
Got it fixed.
Took a while.
Something I needed to know.
Thanks
Mine did this once i cocked hammer back real hard a few times and it quit.
And now for the standard Public Service Announcement when it comes to the trigger group:
While you’re unscrewing the hold down screws, keep your thumb on the plate, and then ease off slowly. There’s a few little springs underneath that’ll go airborne if you don’t watch what you’re doing.
Give the sear spring a bit of a stretch to lengthen it a hair.
Give it a go after that.
My first post.
I have a new to me Condor. I was target practicing.
Something in the safety went south. When you cock the bolt it doesn’t catch. I noticed if I pulled the safety back manually it would catch.
So Its a spring – safety problem.
I don’t know How it goes together.
Any of you have a diagram of this mechanism? instructions on how to fix?
thanks
ziton
Try this ziton
http://talonairgun.com/forum/viewtopic.php?t=4&highlight=trigger
Viewing 7 replies - 1 through 7 (of 7 total)
- You must be logged in to reply to this topic.
the small safety spring popped out.
Anyway its fixed now and shooting good.