Now this is what I call a shroud
I was just looking through my Hard Drive and found the below. It’s probably not very practical, but it certainly has a very cool look to it. Anyone know whose rifle it is, or anything about it at all? Would the vent holes at the muzzle make a practical difference?
All Replies
Viewing 8 replies - 1 through 8 (of 8 total)
Its all in this thread GTBJ.
Ive built 4 or 5 others since this one, but its built exactly the same way.
http://talonairgun.com/forum/viewtopic.php?t=1168
Dunno if the video is still there, if so it should give you an idea of how well it works.
hey riff, could you throw up a pic or two?
Ya thats too big LOL.
Once you get to a certain volume, your wasting space.
My shroud is ridiculously quiet, yet small compared to most here. Maybe its just the air where I live, (2500 feet above sea-level).
I use 1.25″ ID x 12″ long for my 24″ barrels. I made one 1.5″ x 18″ once just to satisfy my curiosity. I actually couldn’t tell the difference noise-wise, but it was like adding a bat to the end of my rifle.
Just go out and buy one, I’m sure any good builders-merchants will have them. 😆
I’m gonna make me one of those! 😀
Ha, that’s ridiculous! I bet it probably just barely weighs enough to not tip over forward.
LOL, it looks like a .50 BMG now.
Viewing 8 replies - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.
now I remember that thing, that carbon fiber is awfully nice 😀
Thanks riff.