Packrat, You Da Man !
The info you gave on converting Ninja Reg from spring to Belleville washers was spot on ! I ordered the disc washers from McMaster & installed in the arrangment you suggested. Gave me an output of 1300 psi. I was looking to get to 1200 but I think it will probably settle back a little with some use. Thanks again for the info, it saved me a lot of time & air I would have used to figure it out myself. I don’t care what everyone else says, I think you are O.K. !!! 😆 😆
Rocko
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
test
test
ROCKO–you’re more than welcome…it’s what these forums are for…helping each other..
NOODLES——
UUHHHHH you could just read the posts on the regulator stuff…that way you get to maintain your dignity, etc.etc. 😀
test
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
It’s all good…. 😀