ProChrono
My ProChrono arrived today and I have just set it up in the garage though I am no readings from it at all. I am thinking its probably the poor light??? Any thoughts or advice is most appreciated.
Thanks 🙂
All Replies
Viewing 8 replies - 1 through 8 (of 8 total)
Does an Englishman drink tea? 😆
Have I ever mentioned a Combro…. 😆
Hopefully it works in daylight… I never had this many issues with mine… I bought the LED light setup and it’s great indoors!
Thanks Synopsys I tried with and without the white screens but I get the same results. I will give it a go in daylight tomorrow and hopefully will have better luck then.
Did you use the white screens between the lights and the chrony?
I find this helps shield the bare bulb from the sensors…
lol yes I managed to get that far 😆 I turn it on and it shows “8.8.8.8” then “rdy” then “0” and then I shoot over it and it just stays at “0”. I have tired messing about with the lighting but it still only sits at “0”. But if I simple wave my arm over the top of it I get “Err”
Zilog; Did you try turning it on and actually shooting through it? AKULA
Viewing 8 replies - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.
I have well should say had a Combro but it imploded. The rear sensor assembly some how got sucked inward. I tried to put the thing back together again but gave up in the end hence the ProChrono. Good news it that it works perfectly outside so I will just have to get myself some proper indoor lights for it now. Thanks for the help guys 😀