Pulled the MUtant 22 out ,
Using Bizills magazine holders way cool, No fumbling in the pockets , No trying to open a pill bottle for the magazines , Just pull it off the side and stick the empty on, Right up there with the Cricket holders , One handed holding the gun, Super cool.
But my 22 Mutant was giving me a big puff of air in my right eye,
Got the FBI, CIA, and the cops and every body else looking for the special tools for the O rings,
That was a fuck up putting them SOBs in, Then I broke the dam gun, Shit.
Mike
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
Thanks Greg
Its not had changing barrels, But that is when the puff started,
The Linstone barrel is on now just so I can shoot a lot of different pellets, Even the unshootable H&N Barracuda hunter at 18,21 gr
Shoots pretty good at 30 yards,
Mike
What you broke ?
I know it’s a bitch to install a new Breech O-ring on the Mutant, it’s far way inside.
Use a wooden dowel and insert it down the barrel ending just shy of the O-ring groove.
Lube up the O-ring and give it a pinch squeeze into the groove.
May need to use a plastic fork to help to hold it in and push it with a finger.
The other way is to remove the barrel.
The barrel is just butted up against the Breech O-ring inside of the receive.
But, that can be a bitch time to do.
So if you ever pull the barrel it’s a good time to replace the breach O-ring while you’re at it.
~ Greg
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
Mike
That’s good to hear !!
Whenever I swap out the barrels I always engage the safety first before loosening the frame hexs.
It helps to keep the frame at the same trigger break location when tightening back up the 4 frame hexs.
If not, if the frame slips too far forwards and pulls on the trigger rod, the gun will not cock.
~ Greg