Visit Talon Tunes
Updated on July 30, 2013
crazy-sniper
Participant
July 30, 2013 at 9:34 pm
Q:

Re zeroing scope help

So after I installed the TTTA I had to move my scope back (now I know I changed the POI) so how do I re zero my scope from around seven to ten yards (length of garage) out to different distances I have a UTG 3-9×50 AO Rifle Scope, Illuminated Mil-Dot Reticle, 1/4 MOA, 1″ Tube, 3/8″ High Rings  I know that if I use the mill dots while sighting it in I can adjust the distance but I don’t know what one to use (still new to scopes I’ve always used iron sights or stuck with the set distance)

Sent from my DROID RAZR using Tapatalk 2

General Chat

All Replies

Viewing 2 replies - 1 through 2 (of 2 total)

knifemaker
Participant
July 31, 2013 at 3:02 am

Go to the Hawke scope sight. They have the charts.

KnifeMaker

crazy-sniper
Participant
July 30, 2013 at 11:15 pm

Even of someone has a formula to figure it out that would be helpful everything I find has the scope sighted in at 100 yards

Sent from my DROID RAZR using Tapatalk 2

Viewing 2 replies - 1 through 2 (of 2 total)

  • You must be logged in to reply to this topic.