Sick of loose pellet tin lids….
Put one wrap of thick electrical tap around the can’s lip, not the lid…if the tape is real thin, use two wraps.
Makes a big difference. It will help out for a good while, at least.
All Replies
Viewing 6 replies - 1 through 6 (of 6 total)
Now you´re being ignorant again.. The rubbing is done to keep them Pellets feeling all warm and cosy , thus happy and willing to hit the target. The circular motion is to make them ready for the swirl they get induced when they get pushed thru the rifling.
You shouldn´t speak about things you clearly have no knowledge over. Bad Uncle ! :twak:
Cost a couple of USD and The Unkie doesn´t have to get fatter by eating that pesky Ice Cream.
GIBLET BREATH!!!
Have you taken leave of your wits?
That’s far too much trouble. Obviously you didn’t watch the video fully.
You must toss the tin of pellet back and forth between two hands, then rub the top in a circular motion, then you must push on the top and lift to get the stupid lid off!!! Are you nuts????
With the new ” Hoot: O-Matic” technique, you just pull the lid off and push it on. The “Magic Tape” ($10.99 usd) comes with not one, but TWO strips of adhesive, (act now and get free shipping)
Honestly, it’s all I can do to keep you ingrates on track.
Kindest regards to the lesser endowed…
Uncle Hoot:
… or you get one of these : http://www.rangesports.com/acatalog/PelletSafe.html
Cost a couple of USD and The Unkie doesn´t have to get fatter by eating that pesky Ice Cream.
My god Keyser, Hoot’s fat enough without eating all that ice cream. You ever see him in his red thong??
This ice cream is pretty good and the containers make awesome pellet cans. The lid is perfectly sized for a Cricket or Edgun magazine speed load.
Viewing 6 replies - 1 through 6 (of 6 total)
- You must be logged in to reply to this topic.
Oh!
Hoot: