Stealth Beancan silencer Thread size?
Can anyone confirm the thread size / type on the stealth silencer ?
Thanks
All Replies
Viewing 5 replies - 1 through 5 (of 5 total)
Sorted thread is 3/4 UNF ,I have cut the thread on my M-M adaptor and it works a treat . Thanks for the feedback .
Are you thinking of a male to female adaptor then? Male to the silencer and female to the collar Inside the frame? I’ll post a pic of my adaptor later but It just slots Into the frame (once you have removed the bean can collar) and grub screws In place exactly the same as the beancan collar does. Only difference Is It has the 1/2″ UNF male thread on the end.
I agree , I am looking to make an adaptor so I can fit a Logun 1/2 ” UNF silencer , just need to confirm thread form I think its 3/4 UNC but need to confirm as I would have to get a die to cut the thread.
What are you planning on doing? I found the bean can a load of shit so just bought a QGS and have got the HW I’m gonna test too. Obviously there different thread sizes too If your thinking of swapping them straight….
Viewing 5 replies - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
Long as your sorted 😉