All Replies
Viewing 6 replies - 1 through 6 (of 6 total)
That is not too bad with Kodiaks!
I was thinking of another option; buy AA410ERB and make bulpup out of it. Maybe sounds too crazy but it is possibility. Just the magazine position is not so convinient for cheeck weld. But that is just an idea
Shoots in the low 800’s with 21 gr Kodiaks.
Straight shooter has the Classic air tube for about $100 shipped.
Pomona Airgun does a power wheel mod that gives the most fps in the AA. He charges $65.00, plus shipping. He’ll do the Classic air tube for $90 plus install and shipping.
Probably cheaper in the long run to buy the Classic to begin with. There’s only three inches difference between the two.
Hoot
Hoot, how fast does your AA carbine shoot? Did you do any power mods on it? Where are you going to buy the classic tube?
Sorry, a lot of questions but I am really fired up to buy one. It will probably take me a while but I will do it.
I was just also wondering does classic tube has the same air volume as AA410 ERB or the latter one is larger?
Thank you
http://talonairgun.com/forum/viewtopic.php?t=9271&highlight=classic
Another pic of a Carbine with the Classic tube. Dont leave much room for a mod on it.
Hoot,
Don.t know the length, but here is what you will have….
http://www.network54.com/Forum/79537/message/1253543510/I+have+a+classic+air+tube+on+my+S410+carbine-+It+will+only+fit—
this is what I was going to do….
http://www.network54.com/Forum/79537/message/1254357963/Check+this+out!++It+works+quite+well.
HTH…. Matthew
Viewing 6 replies - 1 through 6 (of 6 total)
- You must be logged in to reply to this topic.
Hope it’s useful.
Carbine: 300mm
Classic: 400mm
Xtra: 520mm
Best regards,
Filipe