Trigger issues again :(
👿 👿 👿
ok i got my heavy hammer ans spring from rowdy lastnight
so i put them in put gun together and the trigger wouldnt hold the hammer
so i think maybe to heavy a spring so i put stock spring in and smae thing
so i mess with every thing cleaning and crap well today i put stock spring in the heavy hammer and hammer weight
it will hold on pw 3-4 but as soon as i turn it up to 5 or higher i wont hold again
i put a stiffer spring in the trigger and the gun wont only cock back about 1/2 inch
so i stretch a stock spring a bit it wont hold
i take trigger bits out nothing bent or wore out
all seems good
i have went through the QR section over n over i cant figure out why this gun is doing this
when it is on pw 3 i chronyed it and it was 408 with 18 grainers also but im not sure of my tank pressure i gotta grab my pump from mischief to see what my tanks at but i still have the trigger issue anyone have any idea whats up here?
All Replies
What Walter said. Can that Safety!
replace the sear and intermediate lever/sear bar
throw out the safety
Walter….
will do walter
imgonna order from af today
bits are either bending or worn out or adjusted to an unsafe condition
replace the sear and intermediate lever/sear bar
throw out the safety
Walter….
Mine does this every once in a while. I just fight with it and yell at it until it gets fixed.
Try stretching the spring out that holds the sear, that may help. Move it as close to the end of the sear (towards the front of the gun) as you can, that will give it a bit more force. Also try rotating the hammer a bit. I know it’s weird sounding, but the hammer was the majority of my problem, edges were worn out.
And while doing this, try not to wrap it around a tree. 😆
- You must be logged in to reply to this topic.
saftey is gone already and still have the issue 👿
im gonna bend the sear bar up a tidbit n see if it works if it does ill order a new trigger sear etc