types BOLT?
Anybody know were i can get BOLT Or know the name of the type
1) 
2) 
Thanks
Wesam
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
It’s called a “banjo” type fitting; I saw some while I was searching the ‘net. You may have problems finding some small enough.
Later, Gerald
quote Meho:
Wesam,
Can’t help you with No 1 but for the clevis shown in No 2 try Tower Hobbies website at this link: http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXK076&P=7
Hope this helps, Mike
Mike,
Thanks for the help,
Regards
Wesam
Wesam,
Can’t help you with No 1 but for the clevis shown in No 2 try Tower Hobbies website at this link: http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXK076&P=7
Hope this helps, Mike
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
[quote]
Can’t help you with No 1 but for the clevis shown in No 2 try Tower Hobbies website at this link: http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXK076&P=7
/quote]
Yes check out Tower Hobbies for the clevis. They have 3 or 4 brands, Sullivan is the best imo. They come with a little clip that goes on the pin to lock it on. Its what I always used when I used to fly giant scale R/C airplanes ( 81″+ wing spans with chain saw motors ) and helis. They come in 2-56 and 4-40 thread sizes. Depending on your application you may want to put a nut on the rod before the clevis to use as a jam nut. DuBro is another good brand. They come in the same sizes and have ones that are solder on and others that are made of nylon, but I would stay away from the nylon ones.
As far as the bolt? I wouldn’t call it a bolt but not sure what I would call it. What size is the thread? Perhaps something like this will work for you.
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXD923&P=0
e-mail or pm me if I can be of any other help.