valve seat dimension
Hello to everyone,
Need to know the valve seat diameter on the condor high flow valve.
ie The diameter of the air inlet on the valve stem guide.
(On the CO2 kit it measures 7.94mm for a depth of 10.2 mm.)
Can anyone help?
Roland.
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
yep, its the same v spring.
Thanks tagdagger!
That was really quick and precise.
Noticed that the larger opening of the CO2 valve took a lot morer impact-shock to get the valve to open.
Also, the CO2 kit valve return spring dimension are
Wire diameter: 1.2mm
spring ID: 6.6mm
No. of turns : 8
Total length: 19mm
Does this match with that of the high flow valve?
Thanks again!
At the point of contact where the delrin valve seat meets the top brass insert the id is 6.35mm. There is a bigger step cut thru the middle that ids out to approx 7.5mm then back to 6.35 at the top where the hi flo stem passes thru.
Point of contact on the delrin v seal ranges from 7.5 to 9mm depending on if its the older champered seal or the newer squared off one. The older type moved more air.
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Thanks Tagdagger!!!