Q:

Winchester 190?

i shot my wincester 190 today and it shot ragged holes at 50 yards using shooting sticks. I was using cci standard velocity ammo. i was wondering what standard ansi dementions means when it is used on cci high velocity ammo. And i was wondering if i could shoot them out of this old gun. Im not going to risk blowing it up. But i would like to use them for hunting if posible.

Other Guns

All Replies

Viewing 4 replies - 1 through 4 (of 4 total)

quote 07condor22:

http://www.rimfirecentral.com/forums/showthread.php?t=358335

This is the answer I got from Rimfire central: Winchester forum

BRinBama Wrote

All I can say is that my 190 eats everything I feed it. CB shorts to high velocity LR. So in the short run, no it won’t hurt. Now in the long run after several thousand rounds; maybe. But I doubt it. The 190 is a tough old rifle.

Sam 😎

Ty

http://www.rimfirecentral.com/forums/showthread.php?t=358335

This is the answer I got from Rimfire central: Winchester forum

BRinBama Wrote

All I can say is that my 190 eats everything I feed it. CB shorts to high velocity LR. So in the short run, no it won’t hurt. Now in the long run after several thousand rounds; maybe. But I doubt it. The 190 is a tough old rifle.

Sam 😎

quote 07condor22:

HV 22lr should be ok for your Winchester 190, but the HV .22lr will not be as accurate as the standard or sub sonic Velocity ammo. The sub sonic may not cycle the bolt, don’t use CCI subsonic!

Call Winchester or a local gunsmith, they should know.!

There are three chambers I know of for rimfire .22, Short chamber, long rifle/standard hunting/plinking chamber and the “Bentz Target chamber”.

I will post your question on http://www.rimfirecentral.com and wait for their response?

Remington subsonics cycle but aren’t much quieter then regular .22lr. I tried rapi fire and one subsonic jammed but the standard velocity cycled fine.

HV 22lr should be ok for your Winchester 190, but the HV .22lr will not be as accurate as the standard or sub sonic Velocity ammo. The sub sonic may not cycle the bolt, don’t use CCI subsonic!

Call Winchester or a local gunsmith, they should know.!

There are three chambers I know of for rimfire .22, Short chamber, long rifle/standard hunting/plinking chamber and the “Bentz Target chamber”.

I will post your question on http://www.rimfirecentral.com and wait for their response?

Viewing 4 replies - 1 through 4 (of 4 total)

  • You must be logged in to reply to this topic.