Woo-Hoo!!! New Molds

Christmas in July! 8)

I just got a shipment of two different Molds today. One, a 5 cavity NOE RD mold that I sent in to Eric at HP Mold Service to have all 5 cavities HP’d. It’s going to make a Kick Butt Varmint Bullet for We .257 AG Shooters!

I’ll clean her up and cast/test bullets this weekend. If all goes well, I have a couple of test to conduct with them. I will be offering limited amounts of these here on the forum “IF” they meet my requirements. And I’m pretty darned picky. LOL

The second mold is a fairly rare NOE bullet that is very similar to the Ideal 102 gr. Spire Point bullet that RJ and Tofazfou have had such good luck with. If it does well, I may very well deck the mold down about 15-20 grains and have half of the cavities HP’d as well. It’s a 4 Cavity, in typical NOE High Quality. (I talked to AL at NOE about the possibilities of what I was wanting to do with this bullet, and he was very helpful in the plan for it).
This should be an excellent wind buck’r. With a Very High BC.

Man, Talk about Christmas in July. 8) Casting Custom Bullets and Shooting all Weekend. Now what could be better!!! ;D :8:

Knife