would the barrel take an 1/2"unf thread ?
well .. would the barrel on my Stealth take an 1/2″unf thread ?
it looks dam close when comparing it to one of my bsa s10’s,it’d solve a few probs for me as Im not far from cutting the front of the frame down slightly to put a mod directly onto the barrel,
Thanks,
JJ.. 🙂
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
Have you got a standard LW 16mm OD barrel? Or one of those skinny assed 10mm jobbies??
storm is the 18″ barrel then yes it works…..the 12″ barrel you can cut it on too, but no shoulder to align stuff with so you basicly has to custom thread the barrel and ldc to very tight tolerances
Yes, it works very well. I have my barrels threaded 1/2-20.
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Its a 12.12mm (although the digi cal’s arn’t working too well)
it does look like it’l “just” go on but not sure if it’l do the job,
“so you basicly has to custom thread the barrel and ldc to very tight tolerances”
Thats me buggered then 😆
Ive been shooting a couple of times this week with the old Stealth,took the chrono with me to the club and found it was doing 8.2 fpe tops :shock:,
when I made my 1 piece top hat/stem I drilled the hole last,so other than drilling again risking it going over 12fpe I may have to make another 😎
The consistancy is showing 10fps over 10 shots so its not too bad,but the accuracy sucks as Ive put in an old barrel,I just recrowned it and the groups are the same size (about 1.5″ from the bipod at 20yd)
Maybe I need to learn how to crown a little bit better 😆
JJ..