https://talonairgunforum.com/members/e30jef/activity/ Activity feed for e30jef. Wed, 29 Apr 2026 16:09:21 -0400 https://buddypress.org/?v= en-US 30 hourly 2 37819c70d841595d89db30bfe116b357 https://talonairgun.com/forums/topic/talon-ss-farce-or-force-bottle-valve-troubles/#post-217148 Tue, 13 Jan 2015 16:29:40 -0400 “To bad you did not think to use it in the first place since….”
In the first place?
So I get a new gun and then I am expected to assume the responsibility to closely examine, QC and test all the fasteners to be sure they are sound?
Why the hell should I have to LockTite a gun I paid nearly 600 bucks for? On any of the fasteners? Sounds like an…Read more

]]> 17502c8c4a57dcf65ca7e3d015c28195 https://talonairgun.com/forums/topic/talon-ss-farce-or-force-bottle-valve-troubles/#post-215651 Sat, 20 Dec 2014 21:51:09 -0400 I use Green not blue. Both thick and thin. Blue is the bottom feeder of screw holding goop. Blue is good for eyeglass screws and toys.
If the CA reaches kindling temp in side the bottle, then how come that same temp doesn’t affect the delrin pin … especially on the pin’s thin sections and edges? That high of temp would definitely telegraph its…Read more

]]> 360c9b4f9e3b4de1ab99d9ca3ccf659d https://talonairgun.com/forums/topic/talon-ss-farce-or-force-bottle-valve-troubles/#post-215615 Fri, 19 Dec 2014 20:25:29 -0400 FOLLOW-UP:
After studying the guts pic above, and using the gun over the last days I have come to this conclusion:
As the large brass fitting towards the inside-the-bottle end of the valve slowly backed out, it changed the rate on the pin spring. The now soft condition of the force returning the valve pin to sealed position allowed the bolt to…Read more

]]> 7d4b24410dc8312333194f1ee5f15e21 https://talonairgun.com/forums/topic/talon-ss-farce-or-force-bottle-valve-troubles/#post-215556 Thu, 18 Dec 2014 15:36:14 -0400 Epilogue:
I wish I had thought of this BEFORE I reassembled the thing. I could have installed the Manometer and the fill port on the SAME SIDE … making it easier to see the fill register as it happens.
Doh!

]]> 51832385265c9e0d9d606f6282c27e4d https://talonairgun.com/forums/topic/problem-with-new-style-trigger/#post-215523 Thu, 18 Dec 2014 03:21:19 -0400 Hardware store. Bought a finer gauge wire size. A coil that was way too long, but snipped it to what I needed. Good thing is was long … it took a couple of tries to get the length right for feel and snap back of the trigger.

]]> 133078e526790ce5405d69671656cd7a https://talonairgun.com/forums/topic/problem-with-new-style-trigger/#post-215475 Wed, 17 Dec 2014 19:50:17 -0400 This happened to me as well. There’s a small figure 8 shaped lever close to the middle spring perch, along the safety bar side of the the trigger guts channel. It pivots on the pin located closest to the barrel shroud. Be sure that fits into it’s slot in the safety lever bar when you install. Load up the lube so it runs smooth.
I need to make the…Read more

]]>