If your asking about the screw on the top hat itself, and loosening the top hat so it screws up and down on the valve stem to put locktight on it, yes you can.

You can even take the valve stem compeletely out of the valve with air in the bottle and put it back in, the derlin seal that will slip off the valve stem will…Read more

Yes it really effects accuracy badly.

I have had to tighten those screws many times, and they still have come loose many times, and yes I use blue locktight.

The best method I have found is to put the locktight on the valve stem, screw the top hat back and forth before it sets up to coat the threads, then set it with…Read more

I use talon bottle and valve with standart spring.

cheers
Markus

yes, 16 mm OD

the brown one at the bullet breech? it is some fiber from the anti rust paper that sticked.

Now you need a hiflow…right?

Markus, you screwed yourself all up.

You will never again be able to shoot your gun with the smaller barrel.
Once you shoot that .25 and hear that rewarding loud thunk of the pellet impact, you just can’t go back!
You will…Read more

and with power setting 8, I got good 40 shots 770-800 fps

Bench rest shot with ldc installed

I haven’t chronied it yet.

power wheel at 6.

range 35 meter or about 38 yards.

the smallest group is 13 mm, and I think it will become better and better, I just still search the maximum power and…Read more

the picture after the barrel installed, looking very long, but haven’t shot yet but i hope it will be accuracy better.

I got it from my friend from US, the breech is just fit it no modification need it.

what caliber do you have? and barrel length?

I suspect that 177 cal is not good for talon?? who knows?

.22 cal 24″ may be better?

also why do you change the barrel? bad crown?

at 30 yards you should be under a dime with most pellets like Pab’s said.

eun jin pellet has any oil in the tin and with cudas I don’t give it any oil.

can I put wd40 into the pellet?

Could simply be your rifle does not like those pellets. Try JSB heavies.. 😉
Could be the shooter… 😉
Is the FPS consistent?
Are you using a light hold on the rifle (as the…Read more

Could simply be your rifle does not like those pellets. Try JSB heavies.. 😉
Could be the shooter… 😉
Is the FPS consistent?
Are you using a light hold on the rifle (as the frame can flex a little if…Read more

Ok, I got what you mean, thank you for the advice, will try it tomorrow

Did you reposition the extra spring under the sear so now you have two springs pushing up on the sear? (the blue part in the diagram)

And yes you’re correct,…Read more

I have tried to remove the safety block inside the trigger mechanism.
take it with the spring also, but after take it, my talon won’t cocked.
it always release, if i try to cocked it.

why?

thank you
markus

my trigger mechanism is the new one like GlennD and LTlurker said at the diagram.

so can it work? I mean after I…Read more

You’ll get more shots per fill and consistency with PSI I think under 2600.

I lost most of my notes when I got my iphone wet.

this is the picture

How can you not know where the for arm screw goes? Grab the actual for arm and see where it lines up.

Mine does not have that grub screw between the trigger and safety. Maybe some guns do..others don’t..I don’t know. There was a trigger adjustment mod where a screw was added in…Read more

can I know the long between the end of the frame to the end of the barrel?

I like of your talondor, and I at the step of choosing between regular talon frame or talon SS frame.

need your help/information

thanks
markus

Hi, interesting and cool talondor.

Is it talon frame but with 24″ barrel? really beautiful

thanks
markus

how much you get it if I can know

I can see why it would happen though. My experience is limited to Crowmags and Crosman pellets which appear to fit pretty well into the barrel.

All these rifles are pretty different even if they are the same model. :wink:…Read more

In short: regulated guns present the same pressure and volume of air to the pellet regardless of tank pressure and volume. This means consistent velocity (therefore accuracy) and higher shot count.

Regards,
Jim

so if I installed E-TAC on my standart rifle it will become very stable?

and can it give me more…Read more

OK, my idea is just use talon frame and use a few caliber barrel for it.

I think I will buy second hand talon with .177 18 inch barrel and buy another barrel .22 and .25 next for…Read more

OK, my idea is just use talon frame and use a few caliber barrel for it.

I think I will buy second hand talon with .177 18 inch barrel and buy another barrel .22 and .25 next for swap.

I think I will use…Read more

which is more accurate?

which is give more shoot/fill?

which is give more power?

I ever own an condor but never tried hw-100

1/2 inch group @5 shoots at 15 yards with .177 RWS Superdome 8.3grain

750 fps = 10.37 fpe

sitting position.

but the trick is to do so without adding harshness to the gun.

Also bear in mind that spring alone does not create power in these guns. If you have an out of round compression chamber which is…Read more

Please keep in mind, you can easily swap barrel .177/.22 cal without additional parts require, but if you want to swap it with .25 cal, additional parts does require.

Heavier hammer/spring will…Read more

My HW-97K

but can I got higher velocity with my original spring? if I put a few washers below the spring to give it high pre load?

thanks

I had such a bad time with your specific issue on my RWS 350 that I gave up and reverted to the RWS iron sights. I can light up anything inside 25 yards (my vision limit) with that setup. Never lost zero in 18 months since the change.

I’ve…Read more

yup, this kick hard and I remember when I go to the shooting range, I put my HW-97 at gun holder (Y shaped piece of wood) then I shot, I heard the strange sound like a bed hit by stick.

and after that my scope lost zero for a moment.

I think…Read more

You can’t swap barrel with the Marauder.

it is very difficult to buy .22 or .25 cal pellet here, I will save .22 and .25 just for hunting and for everyday practice I will use 177 cal.

I think condor or talon ss is my choice with full .24 inch .22 barrel(for hunting) and .12…Read more

Also recommend to try a different scope?

Same happened to me and the rifle’s stock screws were loose.

Sam 😕

rifle stock screws is sometimes loose, but I have tighten it.

scope mount seem very firm because the scope not move.

but will check again today

i think marauder is good for budget, not too expensive but can I swap the barrel to .177…Read more

Changing the barrel on the HW100 would be to downgrade the rifle’s potential, unless you changed it to a LW of a different length or caliber.

I agree with the above post. Get the Marauder .25 and play with it. Lots of power and modifications are less expensive.…Read more

for mine 9mm im copyng the AForce design, (linear bolt and hammer and tank as butstock), bur in 1 1/2″ diameter aluminium tubing.

please, can you show me the picture of yours?

“im copyng the AForce…Read more