German cricket leaking again…
Hei guys, so i am back with a new leak, i think its the 2.
Indicator hole, cause theres some grease around it.
I changed all the o rings at the regulator but it is still leaking.
I dont know what else i could do, need some help.
Greatings from germany
All Replies
I build this, to remove the pressure gauge, found one on ernests website, but decided to make my own one.
Attachments:
Its the gauge
You re welcome
Sent on the go from my pocket.
Today i build a gauge remove tool, took me 10 minutes.
And about 6 dollars.
What did you build? Care to share or post a picture of the tool?
Its the gauge
You re welcome
Sent on the go from my pocket.
Today i build a gauge remove tool, took me 10 minutes.
And about 6 dollars.
Worked great, condom was still flat after 1 hour.
Think it doesnt leak anymore.
Hope my english is not to bad^^
I think i will build my own reg tester
Do you have a link?
No link, but an email adress, he sells the cricket in germany and spareparts to.
kwirgl@gmail.com
Its the gauge
You re welcome
Sent on the go from my pocket.
Do you have a link?
Found the leak, kondom worked great :8:
Its the gauge
Sent from my iPad using Tapatalk
I will try at weekend.
I dont do anithing, till my o rings arrive
Great, thank you so much!
Spareparts are easy to get in germany.
But i have never seen a reg tester.
Put a thin condom around the gauge and few centimeters of the cylinder. Make sure it seals well around the cylinder using an oring outside around the condom pressing it towards the cylinder. U will be able to check any small and slow leak that does not make enough bubbles if u use soap or spit or whatever. The condom will slightly inflate if the leak is from the gauge, which i am pretty sure it is…dont venture into regulator stuff for now, until u are 100% sure the problem is not from the gauge
Sent from my iPad using Tapatalk
I bought this reg tester from Dman1114 he is a member here on TAG and does great machine work and I sure he can ship it to Germany.
He can be reached by email or PM him here: http://www.talonairgun.com/forum/memberlist.php?mode=viewprofile&u=99457
I use this same reg tester to test my Crickets, Edgun and Mutant Shorty with an adapter which he makes too.
Or you can contact John Hagan he is Ernest’s machinist and does great work too, but you need to ask him if he will ship it to Germany.
Email him here: hagantool@aol.com
This is the best HST it comes with a degasser so you don’t need to bleed out from the factory AT little hex screw which is known to leak too if over used.
http://en.shop.dase.fi/product/47/
~ Greg
I only want to know, if he ships to germany and what the regulator tester costs
This is his latest website http://ernestrowe.com/
Ernest is a very busy man you my need to call him ?
~ Greg
Ok, thank you very much, i will do so.
An other question, i wanted to order some stuff for my cricket fron ernest rowe, but it seams like his website is still under construction?
- You must be logged in to reply to this topic.
Summer is over here in germany, shot alot with my cricket.
In germany i have to stay under 7.5 joule to own an airgun without fac.
So i was a long time tuning the cricket, reg is set at 80 bars, hst only 3 turns in, now i get 600 shots from 250 till 80 bars, with an es of 1m/s.
Hole in hole at 25 meters.