Advice on 30mm scope rings
So I finally got my scope back from repair after a year and need some rings for it. I have a edgun R3m and the Nikko is the 10-15×60, I was wondering what recommendations there would be for it. I think I have seen someone with that scope on an Edgun, but don’t remember who.
thanks
All Replies
HEY ASSMAN!
I understand the Badger Ordnance are a little over-kill for a PCP
these are Xtra high and I have used them as well
Thanks for all that. Those my be a little more than what was hoping to spend, but ill check them out some more.
I don’t have one but I’ll try to help you figure it out.
This is a 42MM objective, the 30mm rings are 1 inch from the base. The front of the objective sits 12.7MM above the barrel.
Using these rings
This 42MM objective sits 15.8mm above the barrel with these rings
https://www.badgerordnance.com/products/scope-ring-max-50-30mm-high-1-125-30mm-dia-2/
Looking at my setup I think you are going to need ultra-high rings
https://www.badgerordnance.com/products/scope-ring-ultra-high-1-400-ar-15-flat-top-30mm-dia-2/
Hope this helps
- You must be logged in to reply to this topic.
thanks
I’m sure you know, but just a reminder that there is 30 moa built into the rail on the r3m. I would look hard at some adjustable rings. Burris signature have worked very well for me in the past. I’m not sure how much adjustment you have in that scope. Good luck!