EDgun Leshiy tuning and using tipps
Hi Guys,
here i have some Tipps for you what i was noted by making my Leshiy reviews.
The barrel will be holt in place with 2 screws in the front of the gun.
If you forget to lock this screws, the barrel will be push forward by the first shot and damaging your shroud/silencer insert!!
Also, make always for sure that the screws are tight!
If you want to grease the barrel for rust protection so you must tighten the screws little bit more.
The .177 barrel have the most air pressure on the end and must be locked tighter than the other ones!
ED gesign the Leshiy for .25 but i use it as multi caliber gun.
So it comes that i switch often between the Calibers.
Now i see that the barrel locking screws are too short and gos not true alt the thread of the magnet holding plate of the other side.
The problem what can come now is that the tread brackets easier out by often barrel switching.
I changed the old screws to new longer stainless steel ones.
Now all the thread will be used and hold stronger/longer.
If anyone uses Atlas bipods like me,… if you cock the gun the Atlas will be touch the gun end and can scratch it.
Some eclectic tape can protect it ๐
to be continued…
All Replies
Have been playing around with different settings and this is where I’m at now:
Huma reg set at 105 bar, fill pressure 250 bar, 33 shots averaging 899 fps with JSB 8.44 gr.
895
882
902
905
900
897
907
905
901
886
900
903
902
903
907
899
901
901
902
900
893
901
901
901
894
894
903
898
906
910
905
901
883
I’m happy with the shot count and fpe, ES of 28 fps could be better.
Any suggestions?
Shooting JSB 10.3 @ 830 Fps for 27 shots with reg set at 120Bar, SD of 3 and ES under 10.
Is that with huma reg? Do you have the extra tension on the valve spring? What setting do you have on the hammer spring tension adjuster?
Shooting JSB 10.3 @ 830 Fps for 27 shots with reg set at 120Bar, SD of 3 and ES under 10.
Anyone running a .177 Leshiy at FAC levels? What numbers are you getting?
I assumed that was a robot. seriously, it looks like a spam post.
Sorry for the offtop but I wonder why people from the East use the long numbers in their nicks really often.
I want to buy one, how to contact you?
ไปๆ็ iPhone ๅ้๏ผไฝฟ็จ Tapatalk
It would be nice if you make a long insert too that can be used together with the extension tube ๐
I would buy one, that would make the Leshiy quiet as a mouse fart! :8:
Do you make the inserts for .177 cal or is it a future plan?
It would be nice if you make a long insert too that can be used together with the extension tube ๐
off eBay, 1.5mm sticky back Neoprene,
I used 1.5mm Neoprene on the tube for a nicer an non cold cheek weld, wanted to retain the look of the gun so went for this in black. Also put some on points where the bipod can come in contact with the gun with tube folded and bipod with legs both folded and un folded.
Where do you find this Neoprene tubing? I really like this idea
Hi,
Couple of questions:
1. Are the barrels chocked? And if yes how can someone know the correct side (front-back)?
2. For the moderator insert, is it possible to make one specific for 0.177?
- You must be logged in to reply to this topic.
ES is a difficult one with HST being those clicks. Hard to get it exactly right for lowest ES