Q:

**NEW ORDER ***any interest in 4500 psi condor tank

Im working on getting some carbon Fiber tanks, The manufacture will be sending me some for testing. i will send them to get tested and if all goes well i will get more.
Im just looking to see if there is any interest? These are aluminum core carbon fiber wrapped.

Water capacity: 0.5L
Diameter: 60mm
Working pressure: 30Mpa
Length: 310mm
Weight: 0.6kg
Thread: M18*1.5

Not sure on a price yet.

Mods/Machinists

All Replies

Viewing 15 replies - 16 through 30 (of 191 total)

1 2 3 11 12 13

I’ll take one two if you answer Rich’s question.

Dman I’ll take one so put me on your list. Terry 😀

What are you guys regulating the output pressure to, on a stock .25 Condor?

Rich

Ok well i have about 3 or 4 people that have expressed they will buy one….

the company wants a min order of at least 10 or more…. I did this just for the cause of the sport… so i didn’t make anything off these. i don’t want to be sitting on a bunch of them.

so when i get enough people and if everyone still wants one i will do it again….

The MadDog Stock fits just fine. In fact, better if anything! :8:

Knife

Is this reorder still in the works? Anymore Interest?
How much larger is the tank volume in cubic inch water displacement? Obviously ya can squeeze more air in at greater pressure. But physical size difference? Woulda the outside dimensionality oms allow for a MadDog ultima stock to fit it?

quote Zilog:

That’s great new. Would you ship internationally?

I can, but you pay the shipping

That’s great new. Would you ship internationally?

Ok i will be doing another order.

They will be 175$ if prepaid. other wise they will be 200$ if you don’t wanna pre pay.

So who’s In ???

quote dman1114:

man i wish i had a mill,

u may be onto something here….

Hell, you and me both!! For now I’ll have to find someone to do the milling… Not sure how much it’s going to cost. I’ll also need to get some more idea’s in what you guys would want to see in a frame… I think I’ve pretty much got it covered:

Sidecocker
M1913 Rail, monolithic w/20 MOA built in
single side feed (dependent on shooter)
M1913 Rail on the bottom for a bipod

My personal one will use an Edge grip, w/a WOK guard (w/o the AR grip part), and will have a forend that looks like an EBR or a Whiskey 3 Chassis… See below:

It would mount like a stock forend, but with one or two more screws. More comfy when carrying, and would be a nice platform if using a tripod to shoot off of in the field… I think I just jacked this thread- SORRY!! I’ll start another one when I actually get the extrusion 75 cm extrusion…

dman. got my tank in hand. Looks great. Thank you very much! :5:

man i wish i had a mill,

u may be onto something here….

I can’t wait to get mine… I just found out that I can get longer extrusions… I’m getting a 75 cm one- that’s nearly 30″… fuck yeah. I’ll have a 55 cm (21″) one to sell… see for sale board. I can’t wait to get this thing together!!!! Finally!!! 😈

Walter, that new tank is kinda good look’n isnt’ it! Much better than expected. :8:

Knife

Jaime, received my tank awesome!
Now to couple it up to a gun! 🙂

Walter….

Viewing 15 replies - 16 through 30 (of 191 total)

1 2 3 11 12 13
  • You must be logged in to reply to this topic.