New to EDgun R3 0.22 Std
Here is a few of pictures of mine,
Unboxing,
❓
🙄
🙄
❗
and will pick up some knowledge from everyone here,
Thanks
All Replies
I bought this item last week,
Here is how it looks on my EDgun,
Tail Fixture
It works very well for the purpose:D
I have tried out my bipod/monopod configuration and noticed some new issues, the following blogger documents my effort to address them,
Please enjoy it.
I also grinded the rail and made a good fitting too,
The rail isn’t flush on the bottom of the stock right?
DIY drill bench, the base needs to be slanted, a 5/8″ blue marker shown on drill bit, otherwise, it will be through that tail,
It took a few hours to get these two holes ready,
After the mod the bolt flows smooth…I’d like to know how eds gun is because in the vid of him shooting that multi shot, that bolt didn’t show any signs of resistance
Way to go !!! 😀 White lithium grease is also good ……… 😉
If you look at both sides of plate you will see one side is slightly smoother than other.
I cleaned up edges all over and put smoother side towards hammer cocking block with light coat of moly grease on face so block rides nice and smooth against it.
Awesome…I like the smoother action it has with the ramp…but it’s good to know I can always go back to stock.
Correct
Just did the mod for the ramp and I have a question…more like a reassurance…it doesn’t matter what side i file the ramp on correct?….if I wanted I could use the ramp and if i didnt like it i could just flip the plate and use the other side and make the gun just like factory again…right?
Just file a slight ramp into edge so ball has a smoother transition up instead of hitting edge.
Only take a few seconds with jewelers file.
I saw that mod…just wanted to know If any further damage could happen….I assume if filled too much the bold wouldn’t sit in place before locking.
- You must be logged in to reply to this topic.
Here is a 96Y clip I made in last two days, please enjoy the fall color,
http://hfpsair.wordpress.com/2013/10/31/fall-scenery/