Q:

Complete Oring List

Anyone have a complete oring assembly for the Edgun Matador? I am sure things will last for some time I have replaced the bolt orings when I got my gun but just curious if there is a list someplace of all of them thanks Eddie

EdGun

All Replies

Viewing 4 replies - 61 through 64 (of 64 total)

1 2 3 4 5

It would be nice to include a few set of o-ring with the gun.

Eddie, did you look through the manual? the o-ring sizes maybe descript in there.

Yep… The harder orings are not so silicone needy. The hold up really well… I
am not sure which Ed used for the .25 but I have not needed to replace them
yet…

Thanks Jeff I was just curious not expecting to get into any in the valve or anything unless I have a problem, but probably won’t just was thinking about it the other day, I know quite thinking and go shoot it LOL 😆 I did replace one on my bolt it had a cut on it so I should get a few of them for spares, I think it might of been a bit dry, a dab a silcone grease does wonders for orings 😯

quote eddieirvine:

Anyone have a complete oring assembly for the Edgun Matador? I am sure things will last for some time I have replaced the bolt orings when I got my gun but just curious if there is a list someplace of all of them thanks Eddie

eddie, there are only 3 (maybe 4) inside the gun that are all the same
size. 2 (maybe 3) around the regulator/air valve, and 1 that seals the end cap of the air
reservoir. Then there is one that seals the end of the barrel at the transfer
port block. The one that seals the barrels is a either 7mmX1.5mm or a
6.5mmX1.5mm. The others can be gotten from Tony… I think that oldgoat
and I are using 3mmX1mm for the bolt probe… I have plenty probe and
barrel seal orings if you need… Or you can get them cheap from McMaster
Carr…

Viewing 4 replies - 61 through 64 (of 64 total)

1 2 3 4 5
  • You must be logged in to reply to this topic.