Q:

EDgun Matador R3, caliber .30, single shot

Here is some information about new EDgun Matador, caliber .30.

1. Length — it became longer for about 50 mm. due to a new moderator (the same thing will be with the long one)
2. Weight — it became a little heavier due to the diameter of the barrel 14 mm instead of 12 as it was before, but not critically.
3. Moderator — new design, eccentric, diameter 38 mm, no thread on the case, just two O-rings.
4. Sound — VERY, VERY comfortable sound, to my opinion sounds quitter then .22, I can hear only the hammer.
5. Pellet — JSB .30 pellet, weight 2.90 grams (44 grain).
6. Speed of the pellet — with the standard regulator (set at 160 bar) — 270 m/sec (886 f/sec).
7. The energy for standard is 105 Joles (77.4 Ft-Lbf) .
8. Accuracy — about 20 mm (0.75 inch) at 50 meters (55 yards). Below you can see the shots to the bear can at 75 and 100 meters.
9. Barrel — made by Lothar Walther, especially for JSB .30, weight 2.9 grams (44 grain) according to my specification, choked, but very lightly.
10. Shot count for standard — 25 shots from 220 to 140 bar.
11. Volume of the reservoir — 270 cm3 (the after regulator space is bigger then at .22 and .25).
12. Length of the barrel for standard — 477 mm.

On October of 10th I went for hunting in the morning. EDgun Matador R3, standard, caliber .30, 44 grain JSB pellet, speed of the pellet 270 m/sec, one shot, distance about 50 meters. This bird:

Very tasty, by the way.

Here is the place where the pellet got in:

Here is the place where pellet went out:

No chances to survive for the bird such a size (about 6 kg.) A lot of blood on the ground. I am impressed…

At the same day I had 15 free minutes, bad mood and was in need to relax. Went for the nearest wood, took EDgun Matador R3, standard, .30 caliber. It was zeroed at 50 meters, the one I use this morning for hunting. I used Ballistic Calculator “Strelok”, made by Russian guy. I put a beer can at 75 meters and even didn’t tried to use paper to “zero” POI at this distance, just took out my IPhone, opened Strelok, changed to EDgun Matador .30, found that at 77 meters it will be second mildot from the cross and made 10 shots. Here is the result:

Then I made a picture of the can, put it vertical, moved back at 100 meters and shot another 5 shots. Here is the result:

There was a light wind from the right to left, about 2-3 m/sec, I didn’t made any calculations to the wind. Strelok told me that 100 meters will be half a mil down from the fourth mil dot at my scope. I put a fourth mildot to the top of the can and got all 5 shots down to the can.

I didn’t use any rests, tables or anything like that. I was sitting in my car, shot from the driver’s window. To my opinion not bad for such a position. The ballistic of the 44 grain JSB .30 pellets is equal to their other pellets so I don’t need to get used to new corrections by the mildot reticle.

I think I would change my Matador for hunting from .25 to .30 🙂

On October of 11th, just at 7:30 I got out home, took a car and went to woods. In 8:15 or something like that I saw a black grouse on the right side of the road. He saw me also, I stopped the car and watched him, taking R3 .30 ready to shoot, but as it was on the other side of the car I couldn’t shoot. The bird slowly moved to the bushes and directed to the thicket. I opened the door of the car, got out and moved back along the road taking the car between me and the bird. When I was about 50 meters out of the car, I took the right side of the road and moved to the place where I expected to find the bird, slowly. I reached the car, which was on the left on me and in few steps saw the silhouette in bushes, took the gun ready, but couldn’t see it in the scope through the branches. I was waiting about a minute or so, then the bird moved, I saw it in the scope through a lot of branched on bushes and shot. It moved quickly then fluttered for few second and that’s it. I loaded another pellet to the gun and moved closer to it. I found him dead.

I like this caliber as I doubt I could reach him with .22 through bushes. The pellet got in the very back side of him, penetrated through all his body and stuck somewhere near the neck. I was home at 9:30 after gutting it in the garage.

Today, on October 13th I decided to calculate how many shots will I have in standard Matador R3 in .30.

Here is the result.

Not bad, I think, 25 shots with average speed of 2.9 gram (44 grain) pellet at 270 m/sec (886 f/sec), from 220 bar to 140 bar. The average air consumption is 7.3 cm3 per one Jole of energy.

EdGun

All Replies

Viewing 15 replies - 91 through 105 (of 256 total)

1 2 3 6 7 8 16 17 18

Thanks for the update Ed.
I keep playing with these .30 cal. pellets.
Can’t wait to launch them at something.
Frank

Everything is going on according to the plan. Details are in Estonia now and today the assembling will begin. It took as one more week then planned due to some issues at Estonian custom but we solved everything. So I expect we need about a week to assemble all the guns for USA and then all depends on the plane.

Ed

Dear Boelick;

Yes, you can wait also, of course :8: :8: , and let me tell you that my waiting for 2 years for the Edgun was quite difficult, and the Edgun is worths the wait.

you will forget all the patient with your first shot, when you see the hottest velocity with the quietest PCP also the sexiest design as all knows.

the new R3M is really great update, not only for the magazine update, but i believe there is a develop in the reg as well, Eduard has mentioned this in somewhere, said i will leave this to be a surprise for the buyers.

i am quite surprised with the sound level of the Edgun .30cal which Ed, tested on youtub. 😯 😮 😮 and the shot consistency as well.

hope the US guys get their Matador .30cal as soon as possible. (I can guess a huge post when .30cal arrives).

quote Boelick:

While Im not getting a 30, i am getting my first Edgun in 25. I’ve read the posts about how everyone is so excited and can only think of Hemn and his 2 yr wait having to jump thru hoop after hoop just to get his. If Hemn can be that patient then so can I…….Is it November yet??? TONY!!! Where are you?

Serious question though, is this the only batch of 30’s Ed is making? During the discussions Ed had with MG it kinda sounded like that’s what Ed was saying.

While Im not getting a 30, i am getting my first Edgun in 25. I’ve read the posts about how everyone is so excited and can only think of Hemn and his 2 yr wait having to jump thru hoop after hoop just to get his. If Hemn can be that patient then so can I…….Is it November yet??? TONY!!! Where are you?

Serious question though, is this the only batch of 30’s Ed is making? During the discussions Ed had with MG it kinda sounded like that’s what Ed was saying.

Geez it could be months. 🙂 I ordered a pistol in the interim knowing it would arrive on time to play with. Russian too…

quote Fast and Danger:

quote synopsys:

Almost November, just a day and a little.

Shit, the wait is killing me and I didn’t even order anything!!!!! 😮

Oh man. I have R3 30 Long and R3M 25 STD coming. I am having a hard time waiting =)

quote synopsys:

Almost November, just a day and a little.

Shit, the wait is killing me and I didn’t even order anything!!!!! 😮

Oh man. I have R3 30 Long and R3M 25 STD coming. I am having a hard time waiting =)

Almost November, just a day and a little.

Shit, the wait is killing me and I didn’t even order anything!!!!! 😮

I’m counting days too.

Is it November yet???

quote Sir Ville:

Don’t want to act as a Decils Advocate but i fear MG might be right about the release / delivery going to be delayed till mid- to late November.
Someone -with the knowlesfe how to do it = not me) should star a thread with a poll about who pics the right first delivery date.
I say Nov. 13th. Any takers ???

Sent from my iPhone using Tapatalk 2. This POS iPhone sucks though …

Steve, gave me 10 tins to do testing, so I would thing he has more!

Ernest

Good idea. Federal Customs in Florida is a variable for us in the US and they like to sit around and sip coffee rather than inspecting shipments arriving from Estonia. Those darn unions. 🙂

I’ll pick the first delivery is November 16th – opening day of firearm deer season in Missouri. Probably a bit optimistic when you add the days together. Poor Tony has to go through a lot of guns.

quote Sir Ville:

Don’t want to act as a Decils Advocate but i fear MG might be right about the release / delivery going to be delayed till mid- to late November.
Someone -with the knowlesfe how to do it = not me) should star a thread with a poll about who pics the right first delivery date.
I say Nov. 13th. Any takers ???

Sent from my iPhone using Tapatalk 2. This POS iPhone sucks though …

Don’t want to act as a Decils Advocate but i fear MG might be right about the release / delivery going to be delayed till mid- to late November.
Someone -with the knowlesfe how to do it = not me) should star a thread with a poll about who pics the right first delivery date.
I say Nov. 13th. Any takers ???

Sent from my iPhone using Tapatalk 2. This POS iPhone sucks though …

Thanks. I ‘ll pick four of those up too. Then I will have an even 20 tins to start. 🙂 Does Steve carry them? I see them at AOA. The Matador standard is set at about 870 FPS with the 44s so it is already a bit slower. I am hoping for 3/4″ groups at 50 yards or so for the 30 cal. A pure hunter. Like airguns, though, you cant have too many pellets on hand.

Ed says the 30 cal LW barrels need a slight choke for best accuracy at longer ranges. I’ll be curious to see how the Crickets do. I am still eyeing them on next years budget. So what do you think so far? St or LW for Cricket? Will you get to test a Cricket with a choked LW?

quote sniperlabyo:

quote SECoda:

After discounts and shipping (I am relatively close to them), Pyramyd stills works out to over $35 less for 8 tins than the other guys on my calculator ($13.125 per tin). 😳 It’s about 35% difference. Something to dance about. :3:

quote gtcpa:

BobbyB I did the same thing last week ordering 12 cans of pellets only to get the same backorder email the next day.

I then ordered some .30 JSB pellets from straightshooters to get some immediately, and then get the rest from PA when they restock.

Been testing the Cricket with the ST at 940fps & LW at 885fps barrel with the 44g and though they where accurate till I tried the JSB 50g they are a lot more accurate, and cant think of shooting anything else on both Barrel. so try some and you will SEE!

Ernest

quote SECoda:

After discounts and shipping (I am relatively close to them), Pyramyd stills works out to over $35 less for 8 tins than the other guys on my calculator ($13.125 per tin). 😳 It’s about 35% difference. Something to dance about. :3:

quote gtcpa:

BobbyB I did the same thing last week ordering 12 cans of pellets only to get the same backorder email the next day.

I then ordered some .30 JSB pellets from straightshooters to get some immediately, and then get the rest from PA when they restock.

Been testing the Cricket with the ST at 940fps & LW at 885fps barrel with the 44g and though they where accurate till I tried the JSB 50g they are a lot more accurate, and cant think of shooting anything else on both Barrel. so try some and you will SEE!

Ernest

After discounts and shipping (I am relatively close to them), Pyramyd stills works out to over $35 less for 8 tins than the other guys on my calculator ($13.125 per tin). 😳 It’s about 35% difference. Something to dance about. :3:

quote gtcpa:

BobbyB I did the same thing last week ordering 12 cans of pellets only to get the same backorder email the next day.

I then ordered some .30 JSB pellets from straightshooters to get some immediately, and then get the rest from PA when they restock.

Viewing 15 replies - 91 through 105 (of 256 total)

1 2 3 6 7 8 16 17 18
  • You must be logged in to reply to this topic.