Trigger mods…better accuracy–

dis-assembled gun down to the point I could remove the 3 springs and agim accesss to contact points. Only able to get to 2 of the contacts..that was the 2 places on the center piece. To get to the others would mean removing those “pins” or “rivets”..and I’m not up for that..Used some 800 sandpaper that I put a couple of drops of oil on. Maybe 2 dozen strokes or so at each point, then cleaned then up with Q-Tips. Removed 1.5 coils from each of the 3 trigger springs, and put gun back together. Trigger feels a LOT better than it did..smoother and quite a bit less pull 😀 Below are some shot gtoups I did after doing the modifying. They were done at 25 yards..The one where the shots go down is cause I just wondered if I could do it..The other on on that same piece of paer would have been pretty good, ecept for the flyer(my fault, not the gun). The single group, which is just one hole is THE BEST I’VE evers hot with any airgun 😀 😀 😀 All 3 groups were 7 shots..all other info is written on the targets. IMO, that little bit of work on the trigger was WELL worth the effort…

edited to add: those are one inch squares on the targets.