What’s your thought???
Ok so I crono my gun last week. I filled to 210 bar, my 1st shot was 840, 482, 891 845 then 530. Next 10 shots were 912 to 919 then back down to 840, 855,861 then back up to 913 to 919. After shot # 25 string stayed at 912 to 919 all the way to shot # 77. So today I tried again but with a 200 bar fill. 913 to 920 and several in the 530 to 620 range. Then back up again. Is it a bad reg? Or is it set to a lower bar? Maybe it’s Villes scope that has it shooting this way……
All Replies
You should. Also – you can ask Evgeny directly.
Being right handed and trying to get used to cocking with the bolt on the left is still a challenge for me. I double loaded some times until I figured out what was happening. I did finally polish the slot the bolt travels in and that did help. If I continue to have the double feed occasionally, I will probably move the bolt to the right side.
Sounds like what my 25 (he man caliber) did when the stem was lose in the valve, the plastic version. The hammer was loosing energy when hitting the lose stem. Just a thought.
Jk
Sent from my Z30 using Tapatalk
Zonks biggest problem is that he is talking it up with our majestic uncle :bow: :bow: :bow: :hoot: who can’t keep his fingers off anything he has to play with everything. Zonk stop listening to Hoot: its a recipe for trouble. If you are a common air breather you will never understand this Reptillianiod known as Hoot:
Zonk did you mess with hammer spring?
Sent from my Z30 using Tapatalk
Well if tony checks these before it goes out and you have a chrony printout what in the heck happened between now and then.
Sent from my Z30 using Tapatalk
Yes it is to bad. I talked to Tony and he didn’t have a clue as to what’s causing the problem….Maybe I should ship it back and ask for another???
I suppose the groups such too. If not the crony is fishy. But that’s too bad. Very too bad.
Sent from my Z30 using Tapatalk
I think Zonk got his gun from Tony Ville
I always pump my Vulcan too 250 Bar. I know a lot of folks don’t pump this high and say don’t however I do. If I was you Jedi I would pump the gun too 250 BAR run a few more strings through it while running it down too 200 Bar then pump it back to 250 Bar and do it again a few times while running it over the crony maybe it will clear out any gunk you have in the reg if this is the problem and if it is not and you are unwilling to take it apart then ship it back to Talon Tunes for repair or who ever Tony is using to service the Vulcans. This sucks it’s new as baby ballz.
Sounds like a reg issue or Zonk is lending his gun to Lead and who knows what Leads putting on it…… :suprisedn: might be clogged up like Keyers if Lead had his hands on it.
I had that same thing happen on my Cricket. Turned out there was way too much grease on the regulator. I took the washers out and they were full of crud. After cleaning the Cricket was right as rain.
Maybe you got yours from the same supplier as the guy who send his back to the seller just be discovered it had the wrong HS in it ??
- You must be logged in to reply to this topic.
Sent from my Z30 using Tapatalk
No, this was right out of the box when I crono’d. Then Monday I crono’d again from a 200 Bar fill and same thing, shots in the 500 to 800 range then back up to 912 to 919 where it should be.