How is this smooth edge created ?
In the attached image of a tank adapter I can understand the 4 centerlines (red,green,blue,yellow) needed to turn this piece. What I don’t understand is the purple circled area. How is that shaped so nicely to blend with all the other curved surfaces ?
All Replies
😕 😕 😕 😕 Is a TTTA a TTTA or a baznob TA?
Here’s a couple of close pic’s of side cocker. Still going to cut a slot for safety and finish back notch.
i know that this is off-topic, but what pellet speed you get with that puppy?…or we should open a new topic? 😀 your gun gives me a reason to live, and when i will grow up i will buy a gun just like that :))
how much costs the whole thing? 😯
FAP-FAP-FAP-FAP-FAP-FAP-FAP-FAP- 😯 😯 😆 😆 😆
😆
I was going to say, Baz might show you his “knob” but I don’t think his wife would be comfortable showing his “cocking slot”…
😆
This place is like a construction site, you really need to watch what you say even if it’s an innocent question. 😉 😆
oops.. could be a cultural misunderstanding…
Correction:
baz – can you post some closer pictures of the right side so we can see your breech handle and slot better?
oops.. could be a cultural misunderstanding…
Correction:
baz – can you post some closer pictures of the right side so we can see your breech handle and slot better?
Never ask Baz if you can see his knob better….. 😳
😯 😯 😯
😆 😆 😆
Never ask Baz if you can see his knob better….. 😳
baz – can you post some closer pictures of the right side so we can see your cocking slot and knob better?
Very nice Baz!!!!!
Wow Nice – I can’t afford the scope.
Damn! This thing get me high!
Sweet!
Talking about the elbow, its true what a friend say up.
The time to machining this piece are at least 2 days. And, like time is money i dont think nobody sell it for less than 200 us
Just trying to think outside the box and get the cost down to $100
- You must be logged in to reply to this topic.
jetboy1 look at this and you’ll see